ESD-Control Vinyl Floor Covering
Features of tile
1. Conductivity
·It satisfies the electric resistance of UL 779&NFPA 99.
·Surface electric resistance:104-106¦¸
·Static decay time:5.000lts to zero 0.25sec.
2. Durability
·Excellect anti-wear,and anti-chemical properties.
3. Uniform gauge and color maintenance
4. Anti-load property
·There is no problem with machine movement,carrier vehicles
or beds.
5. Permanent conductivity
·Conductive materials is distributed evenly in entire so that
it has permanent conductivity.
6. Non-flammable
Conductive tile (installation method)
Proper supplementary materials shall be used for conductive
tile installations.The function of electric conduction may
be demonstrated only by exact methods of a skilled contractor.
Sequence of installation
1.Arrangement and preparation of floor. Dry conditon without
contaminants.
2.Drawing of tile construction line on floor with chalk line.
3.Drawing of construction line of copper tape.
4.Application of adhesive (drying time 10-20 minutes after
application of electro conductive adhesibe).Use special adhesive
only!
5.Installation of copper tape
(1) Install so that it will be crossed at center of tile.
(2) Leave allowance of about 12'' for copper tape at the place
to be grounded.
6.Installation of tile
(1) Select start point of tile construction after adhesive
dries.
(2) Install from center of chalk lines.
7.Welding of tile connection part
(1) Route V shape groove of about 1/2 times the thickness
of tile along tile seam after adhesive harden sufficiently
to hold tile in place..
(2) Perform welding with welding machine using PVC welding
rod of 3.5 mm diameter.
(3) Level the projecting part of welded part with chisel knife
so that it may be level to tilesurface.
8. Grounding: Do grounding by connecting ground wire (copper
tape) to grounding point if installation
of tile is complete.
Maintenance and control
1 Remove detergent component completely after cleaning using
neutral high quality detergent after removing
dust for general cleaning. Rinse at least twice,more if necessary,with
clear fresh pure water.
2 Clean contaminated parts carefully with mild detergent.
3 Do not use wax. If necessary,use polisher.
Uses of tile
Manufacturing, assembling and inspection factory of semi-conductor
company
Clean room,computer room
Producting,assembling,laboratory,and test place of electronic
product
Operation room of hospital
Place to handle explosives and flammable gas
Access floor
Telecommunication corporation (electronic switching room,etc.)
(finishing material of conduction room)
Supplementary materials
1.Copper tape 0.025T¡Á20mmw
2.Electro conductive adhesive: 104-106\.
3.3.5mm diameter for PVC welding
HT01 |
HT02 |
HT03 |
HT04 |
HT05 |
HT06 |
HT07 |
HT08 |
HT09 |
HT10 |
HT11 |
HT12 |
|
